What is gps?

GPS Signal Errors Sources

Factors that can affect GPS signal and accuracy include the following:

• Ionosphere and troposphere delays: Satellite signals slow as they pass through the atmosphere. The GPS system uses a built-in model to partially correct for this type of error.
• Signal multipath: The GPS signal may reflect off objects such as tall buildings or large rock surfaces before it reaches the receiver, which will increase the travel time of the signal and cause errors.
• Receiver clock errors: A receiver’s built-in clock may have slight timing errors because it is less accurate than the atomic clocks on GPS satellites.
• Orbital errors: The satellite’s reported location may not be accurate.
• Number of satellites visible: The more satellites a GPS receiver can «see,» the better the accuracy. When a signal is blocked, you may get position errors or possibly no position reading at all. GPS units typically will not work underwater or underground, but new high-sensitivity receivers are able to track some signals when inside buildings or under tree-cover.
• Satellite geometry/shading: Satellite signals are more effective when satellites are located at wide angles relative to each other, rather than in a line or tight grouping.
• Selective availability: The U.S. Department of Defense once applied Selective Availability (SA) to satellites, making signals less accurate in order to keep ‘enemies’ from using highly accurate GPS signals. The government turned off SA in May of 2000, which improved the accuracy of civilian GPS receivers.

How accurate is GPS?

Today’s GPS receivers are extremely accurate, thanks to their parallel multi-channel design. Our receivers are quick to lock onto satellites when first turned on. They maintain a tracking lock in dense tree-cover or in urban settings with tall buildings. Certain atmospheric factors and other error sources can affect the accuracy of GPS receivers. Garmin GPS receivers are typically accurate to within 10 meters. Accuracy is even better on the water.

Some Garmin GPS receiver accuracy is improved with WAAS (Wide Area Augmentation System). This capability can improve accuracy to better than 3 meters, by providing corrections to the atmosphere. No additional equipment or fees are required to take advantage of WAAS satellites. Users can also get better accuracy with Differential GPS (DGPS), which corrects GPS distances to within an average of 1 to 3 meters. The U.S. Coast Guard operates the most common DGPS correction service, consisting of a network of towers that receive GPS signals and transmit a corrected signal by beacon transmitters. In order to get the corrected signal, users must have a differential beacon receiver and beacon antenna in addition to their GPS.

What’s the signal?

GPS satellites transmit at least 2 low-power radio signals. The signals travel by line of sight, meaning they will pass through clouds, glass and plastic but will not go through most solid objects, such as buildings and mountains. However, modern receivers are more sensitive and can usually track through houses.

A GPS signal contains 3 different types of information:

• Pseudorandom code is an I.D. code that identifies which satellite is transmitting information. You can see which satellites you are getting signals from on your device’s satellite page.
• Ephemeris data is needed to determine a satellite’s position and gives important information about the health of a satellite, current date and time.
• Almanac data tells the GPS receiver where each GPS satellite should be at any time throughout the day and shows the orbital information for that satellite and every other satellite in the system.

The GPS Satellite System

The 31 satellites that currently make up the GPS space segment are orbiting the earth about 12,000 miles above us. These satellites are constantly moving, making two complete orbits in less than 24 hours. They travel at speeds of roughly 7,000 miles an hour. Small rocket boosters keep each satellite flying on the correct path.

Here are some other interesting facts about the GPS satellites:

• The official USDOD name for GPS is NAVSTAR
• The first GPS satellite was launched in 1978.
• A full constellation of 24 satellites was achieved in 1994.
• Each satellite is built to last about 10 years. Replacements are constantly being built and launched into orbit.
• A GPS satellite weighs approximately 2,000 pounds and is about 17 feet across with the solar panels extended.
• GPS satellites are powered by solar energy, but they have backup batteries onboard, in case of a solar eclipse.
• Transmitter power is only 50 Watts or less.